 |
|
Step 1: Spray the hand or other surface 4-5 times
with Solution 1
|
Step 2: Spray the hand or other surface Solution
2
|
|
If lead is present on the hand or other surface, the surface
will show an immediate color change to yellow. The yellow
color on the hand or surface shows the exact location of the
lead present.
|
Back to top
|
|
| Step 1: Spray the
entire cotton test pad 6-8 times with Solution 1
|
Step 2: Wipe the hand
or surface to be tested
|
| |
If lead is present on the tested
surface, the test pad will show an immediate color change
to yellow. |
Step 3: Spray the entire
test pad 5-7 times with Solution 2 |
 |
The Control
Pad contains four spots of lead. There are two spots at approximately
20 micrograms and two spots at approximately 100 micrograms.
To run a control test, spray the Control Pad with Solution
2. A color change to yellow will occur. A similar
color change occurs when lead is present on the test surface. |
|
|
|
|
If the test results are positive,
clean the lead contaminated area with D-Wipe®
Towels or with a D-Lead® Cleaning product
and dispose of test pads and D-Wipe® Towels
as required by regulations. |
 |
|
| |
| ESCA Tech, Inc. assumes
no liability for misuse of the product or interpretation of
the results by the user. The warranty is limited to a refund
of the purchase price of the product only. Test results should
be confirmed by chemical analysis. |
|
|
|
